Job Description

PRIMARY FUNCTION:

The primary function of this position is to determine the status of service needed for various equipment components( transmissions, engines, fuel systems, etc), perform the necessary service, repairs, replacements, installations, or re-building of parts and to restore the equipment to proper operation.

ESSENTIAL DUTIES:

• Review the work schedule, check the equipment and supplies required to perform the work scheduled, comply with PPE requirements, and otherwise prepare for duties.
• Use manuals, repair manuals, parts manuals, parts diagrams to troubleshoot engines, engine fuel systems, & transmissions.
• Use lift trucks, overhead cranes, & other aides to lift or move parts into position to be repaired.
• Use hand & power tools to remove, install, replace, re-build, repair, & test parts/equipment on engines, engine fuel systems, & transmissions.
• Set-up units in test apparatus, tests & verifies performance, then pressure washes & repaints parts/equipment.
• Use miscellaneous resources and computers to reference parts, get information about parts & enter data into record systems
• Use tools to disassemble/re assemble parts or engines; cleans parts with rags, cleaners, power washer; uses test equipment to make diagnostic checks; and controls powered equipment or tools to make repairs.
• Lift/carry/ mount parts in powered equipment to do necessary grinding, honing, boring, drilling, & polishing, &, make replacement parts or refurbish parts before re-assembly, reassembles & tests units, power washes & paints finished units.
• Use precise measuring tools to determine conditions of all components & to monitor machining work done on components.
• Use hoist & forklift to move the equipment to the test bed & tests the equipment.
• Perform inspections, preventative maintenance, change oil, replace filters, belts, coolants, hoses, may drain/clean/refill fuel systems.
• Pressure wash equipment & paint the equipment for shipment or installation.
• Use instruments and computers to reprogram equipment controllers
  
  

MINIMUM REQUIREMENTS:

Education:

Must have a high school education or GED.

Work Experience:

Six years of experience with at least two years of experience on Cat or other similar equipment

Physical:

Must be able to daily and repeatedly stoop, kneel, bend and climb beside, onto and underneath various equipment to perform diagnosis and repairs. Must be able to effectively see to perform repairs, research technical manuals, and develop written repair work order reports. Must be able to routinely and physically lift/position various parts to perform repairs/service and manually handle parts up to 70 pounds, as well as use mechanical hoist for heavier parts.

Other:

Must be able to effectively write repair activities on customer work orders. Must have cognitive reasoning and problem solving skills to apply knowledge, written information and verbal instructions in repairing/servicing unusual and/or unknown technical equipment operational problems. Should have exposure to P.C. base equipment and parts information

This job description is not intended to be all-inclusive. Your supervisor may request and assign you similar duties. Any major modification of this job role requires Human Resources approval.